Wheel Kit Installation (100302)

Updated by Juan Velez

This bulletin covers the following Champion Power Equipment models: 100302.

Read the instructions carefully and completely before performing service.

In order to center the support leg from the 40065 wheel kit on your 100302 Digital Hybrid, you will need to use the existing motor mount bolt.

When you tilt the machine up to install the support leg, locate the existing black bolt and nut for the engine mount.

Remove the nut, then put the support leg in place, and secure the nut so that lines up as seen below.

Visual
See below.


How did we do?


Powered by HelpDocs (opens in a new tab)